Td-machine-products Brodix Big Block Chevy Bedienungsanleitung PDF herunterladen

Please follow these instructions to ensure the proper operation of your T & D MACHINE

PRODUCTS Brodix Big Block Chevy Rocker Arm Assembly.

1. DETERMINE CORRECT STAND HEIGHT

Install the rocker stands on the cylinder head using the 7/16-14, 12 point attaching

bolts. The stands should be placed on the head so that the stamped letters face

the valve stem. Remove a rocker arm from one of the shafts and place that shaft

on a stand. Take the shaft height gage supplied with the kit and place it on the valve

stem as shown in Figure 1.

The gage should contact the top of the valve and the rocker shaft as shown in Figure 1.

If the gage contacts the shaft before touching the top of the valve stem, as shown

in Figure 2, remove a corresponding amount of material from the stud bosses on the

cylinder head. This will lower the rocker stand on the cylinder head.

P/N 05870

1 2 3

Seite 1

Please follow these instructions to ensure the proper operation of your T & D MACHINE PRODUCTS Brodix Big Block Chevy Rocker Arm Assembly. 1.

Seite 2

If the gage contacts the top of the valve stem and does not touch the rocker shaft, as shown in Figure 3, add a corresponding amount of shims bet

Seite 3

4. FINAL ASSEMBLY After all of the stand heights have been set, and the roll pins have been installed, place a rocker and shaft back on the stan

Keine Kommentare

Td-machine-products Brodix Big Block Chevy Bedienungsanleitung