Td-machine-products Brodix Canted Valve Bedienungsanleitung PDF herunterladen

INSTALLATION INSTRUCTIONS

Please follow these instructions to ensure the proper operation of your T & D MACHINE

PRODUCTS Brodix Canted Valve Rocker Arm Assembly.

1. DETERMINE CORRECT STAND HEIGHT

Install the rocker stands on the cylinder head using the 7/16-14, 12 point attaching

bolts. Be careful to keep the rocker arms in the order that they were removed from the

stands. The stand marked with a "LOE" in the lower left hand corner of the stand is for the

left-hand (looking at the head from the exhaust manifold side) outside exhaust valve. The

stand marked with a "ROE" in the lower right hand corner of the stand is for the right-

hand outside exhaust valve. The stand marked with a "ME" in the lower left-hand corner

is for the paired exhaust valves in the middle of the head. The stands that are marked

with an "IN" are for the intake valves, and are interchangeable. There is a "V" stamped in

the middle of each stand to note that this is the side that faces the valves when installed

on the head. Remove a rocker arm from one of the shafts and place that shaft on a stand.

Take the shaft height gage supplied with the kit and place it on the valve stem as shown in

Figure 1.

The gage should contact the top of the valve and the rocker shaft as shown in

Figure 1.

If the gage contacts the shaft before touching the top of the valve stem, as shown

in Figure 2, remove a corresponding amount of material from the stud bosses on the

cylinder head. This will lower the rocker stand on the cylinder head.

1 2 3

Seite 1

INSTALLATION INSTRUCTIONS Please follow these instructions to ensure the proper operation of your T & D MACHINE PRODUCTS Brodix Canted Valve R

Seite 2

P/N 0588 If the gage contacts the top of the valve stem and does not touch the rocker shaft, as shown in Figure 3, add a corresponding amount of

Seite 3

2. DETERMINE CORRECT PUSHROD LENGTH Place the pushrod length checker into the lifter and install the rocker arm assembly. Be sure the cam is rotat

Keine Kommentare

Td-machine-products Brodix Canted Valve Bedienungsanleitung